Manualshelf

User's Manual

ManualsBrandsTandD ManualsElectronicsWireless Communication Port
31323334353637383940
22
Getting Ready
Setting up the Communication Port
1.
From the [Communication] Menu, select [COM Port Settings].
2.
Place a check next to: [Serial Communication] when communicating via serial
communication cable, [USB Communication] when communicating via USB.
Then click the [Auto Detect] to automatically fi nd an RTR-50 using the currently
set communication method (USB or Serial).
[Auto Detect]
button
Check
3.
After the search, if the message ȨAn RTR-50 unit was detectedȩ appears in
the [Detection Results] box, settings have been successfully completed.
Click the [Close] button to close the Window.
NOTE:
- If the USB driver has not been properly installed, USB communication will not be
possible.
- If no port is detected, see [Troubleshooting] on pages 103.