User's Manual

11
About USB Device Drivers
Have you installed the software?
Before connecting a Unit to a PC with a USB cable make sure to install the
Software first.
For Units using a USB connection, it is necessary to first
install the Software, and upon connecting the Unit to the PC
with a USB cable it is necessary to install the USB Device
Driver. A USB Device Driver enables the PC to recognize
the connected device and ensure proper operation.
- To ensure a proper connection, make sure that the USB cable is inserted fully.
- Login using a User Account with Administrator (Computer Administrator)
rights.
Users of Windows XP must carry out the Installation
Procedure.
Upon connecting a Unit to your PC, the [New Hardware Detection Wizard] will
automatically open. Please carry out the procedures on the following pages to
install the USB Device Drivers for the Base Unit (RTR-
500DC), Remote Units
(RTR-574), and if necessary, Repeaters (RTR-500).
- In XP, if the Wizard window does not automatically open, installation may have
not been fully completed or failed. Please check the USB device driver.
Users of Windows Vista or Windows 7 do not have to
carry out this installation.
By installing the supplied software, the USB Device Drivers for the Base Unit,
Remote Units and Repeaters will also be automatically installed. It is not
necessary to carry out any extra steps to install the USB Device Drivers.
- See page from 28 of this Manual for about how to confirm that the
USB Device Driver has been properly installed.