User Manual

Installing the Software and the USB Device Driver
22
Before Installing the Software
Before connecting an RTR-500GSM to your computer,
make sure to install the supplied software into the
computer.
If you have connected an RTR-500GSM to your computer before installing
the supplied software, make sure to click the [Cancel] button in the Wizard
window when it pops up on the computer display.
Slide the Operation Switch on the RTR-500GSM to the
<STBY> position.
Outline of Software
"RTR-500GSM for Windows" is made up of three applications.
RTR-500GSM Settings Utility
This application is designed to register Remote Units and Repeaters and make
necessary operational settings for the Base Unit RTR-500GSM and Remote
Units.
Temperature and Humidity Graph
This application is designed to enable viewing in graph form the temperature
and humidity data files.
Adjustment
This application allows for adjustments to correct inaccuracies found in
measured values when compared to a standard or reference measurement.
After adjustment settings have been made the data logger will record only the
adjusted value.
Before Installing the Software
Is Windows working properly?
- If Windows is not activated properly, it may be impossible to install and run
"RTR-500 GSM for Windows".
- "RTR-500 GSM for Windows" is compatible with Microsoft Windows XP
Service Pack 2 or higher and Vista. For details about the operating
environment, see page 48.
Quit all applications.
- If you are running other applications, make sure to quit them before
installation. If you have any permanently active software, such as a virus
check or scan program in your computer, make sure to also quit it.
For Windows XP and Vista, in order to install RTR-500GSM for Windows, it
is necessary to have Administrator rights (Computer Administrator) for
the computer in which you wish to install it.