User Manual

9
Introduction
Wireless Regulations
Radio, EMC and Safety Regulations
This device complies with part 15 of the Federal Communications
Commission (FCC) rules and with RSS-210 of the Industry Canada
(IC). Operation is subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Changes or Modifications not expressly approved by the manufacturer for compliance
could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an e
xperienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF r
adiation exposure limits set forth for an uncontrolled
environment. This equipment must be installed and operated with a minimum distance of
30cm between the radiator and your body.
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 0dBi. Antennas not included in this list or having a gain greater than 0dBi
are strictly prohibited for use with this device.

The required antenna impedance is 50 ohms
.
The antenna supplied with the product meets these requirements.
Usable Antenna: The supplied antenna only
Note about SIM Cards
The SIM card stores the user’s cell phone number and other unique user identification
information. Please take adequate care to prevent the loss or theft of your SIM card. Also,
be sure to keep your PIN number in a safe place.
Please note that this Introductory Manual has been written based on the presupposition
that the functions / specifications of the SIM card being used and the details of the
contract have already been confirmed between the user and the cell phone carrier.
T&D Corporation shall not be responsible for any damages which a contractor, a user or a
third party may suffer, whether direct or indirect, due to the inability to use communication
devices.