Installation 4 &LATSCREEN 3ET TOp +IT Unpacking Speaker Set: Audio Cable Remote Control/ Batteries (AA x 2) 2 pcs Speaker Cables Speakers Monitor Power Cord 2 pcs Temporary Stand DVI-D to DVI-D cable Screw kit: Unbrako key 4 x Type A Set top bracket with velcro for monitor ¿[DWLRQ DQG cable strap 5 x Type B (with plugs for brick/concrete wall) Table stand kit: Wall mount kit: Wall mount rail With cable strap Wall brackets D13844.
Installation 4 &LATSCREEN 3ET TOp +IT &RQQHFWLQJ &DEOHV DVI-D to DVI-D cable Audio cable To monitor: DIGITAL RGB (DVI-D)/INPUT 2 To monitor: Audio/INPUT 2 0RQLWRU &RQ¿JXUDWLRQ XVH PRQLWRU 5HPRWH &RQWURO Screen size: ‘FULL‘. Source input: ‘DIGITAL RGB’ (INPUT 2).
Wall mount 4 &LATSCREEN 3ET TOp +IT 1. Put monitor onto temporary stands and mount the speakers according to the speaker mounting instructions. 2. Mount the Wall brackets with 4 x screws Type A. 3. Bend the bracket into correct shape DQG ¿[ RQWR WKH PRQLWRU 4. Place Set Top onto bracket. Make sure velcro strips are matched properly! 5. Connect cables (see page 2) and ¿[DWH LQ FDEOH VWUDS 2YHUKDQJ RI 6HW 7RS DQG bracket is needed for cable space towards wall. Maximum 7 cm. 6.
Wall mount 6 A) Wooden pillars (w/gypsum) 60 cm center-center. 0RXQW LQWR VSHFL¿HG KROHV with 4 x Type B screws 4 &LATSCREEN 3ET TOp +IT 6 B) Wooden pillars (w/gypsum) 16 inch (41 cm) center-center. 0RXQW LQWR VSHFL¿HG KROHV with 5 x Type B screws 7 Hook the system onto the wall mount rail. 6 C) Brick/Concrete wall. 1 2 PP ´ 1. Drill a small initial hole 2. Drill a larger hole for plugs 3. Mount into VSHFL¿HG holes with 5 x Type B plugs and screws.
Table stand :LWK WKH PRQLWRU O\LQJ ÀDW RQ D WDEOH RQWR WKH SURWHFWLYH FORWK IURP WKH ER[ mount the Table stand with 4 x screws Type A. Never use temporary stands as table stand. For help during wall mount purpose only! 3. Bend the bracket into correct shape DQG ¿[ RQWR WKH PRQLWRU Make sure velcro strips are matched properly! D13844.02 Page 5 4 &LATSCREEN 3ET TOp +IT 2. Mount the speakers according to the speaker mounting instructions.
4ABLEäSTAND 4. Place Set Top onto bracked. Place bracket and Set Top along edge of monitor 5. Connect cables (see page 2) DQG ¿[DWH LQ FDEOH VWUDSV 7KLV LV 127 D ÀRRU VWDQGLQJ V\VWHP 3ODFH WKH V\VWHP RQ D ÀDW DQG rigid surface or table. D13844.
