Computer Hardware User Manual

146
To configure monitoring using SNMP, go to .
The MCU sends out an SNMP trap when the device is shut down or started up. The SMNP page allows you to set
various parameters; when you are satisfied with the settings, click .
Note that:
The 'system up time' that appears in the trap is the time since SNMP was initialized on the MCU (and
therefore will differ from the Up time reported by the MCU on the > page).
The SNMP MIBs are read-only.
Identifies the MCU in the SNMP system MIB.
Usually you would give every device a unique
name. The default setting is:
Codian MCU
The location that appears in the system MIB.
An optional field. It is useful where you have
more than one MCU to identify where the unit is
located. The default setting is:
Unknown
The contact details that appear in the system MIB.
An optional field. The default setting is:
Unknown
Add the administrator’s email address or name to
identify who to contact when there is a problem
with the device. If SNMP is enabled for a port on
the public network, take care with the details you
provide here.
A description that appears in the system MIB.
An optional field, by default this will indicate the
model number of the unit. Can be used to
provide more information on the MCU.