Computer Hardware User Manual

112
This setting controls for how long (if at all) the
Codian logo is displayed to participants joining a
conference. Choose from:
When displayed, the Codian logo appears in the
bottom right of a participant's conference display.
Allows you to enter a message that will be seen
by participants joining conferences on the MCU.
The message is displayed at the bottom of a
participant's conference display.
The duration of the message is configured using
the
control.
This setting controls for how long (if at all)
participants joining a conference will see the
conference welcome message. Choose from:
If you want streaming viewers to see the
welcome message, you must configure the
duration as permanent.
This setting controls whether (and for how long)
participants shown in view panes are accompanied
by their supplied name.
The "Conference welcome message" (described
above) and any other overlaid textual messages
(for instance information on how soon the
conference is going to end, or endpoints leaving
and joining the conference) will take priority over
the displaying of participant names for the
duration of those messages.
You typically only need to modify these advanced settings if you are working with a support engineer or setting up
more complicated configurations.
Restricts the MCU's choice of audio codecs to be
used for transmitting audio to endpoints.
When communicating with an endpoint, the
MCU receives a list of supported audio codecs
from the endpoint. The MCU chooses an audio
codec from those available, and sends audio data
to the endpoint in that format.
Note that the Custom codec selection setting for an
individual endpoint will override this unit-wide
setting for calls to that endpoint.