Codec C90 Administrator Guide
Table Of Contents
- Introduction
- Getting started
- About the menus
- The Settings menu
- Administrator Settings Library
- Description of the administrator settings
- The Audio settings
- The Camera settings
- The Conference settings
- The Do not disturb setting
- The H323 Profile settings
- The Network settings
- The Camera settings
- The Phone book server settings
- The Provisioning settings
- The Serial port settings
- The SIP Profile settings
- The Standby settings
- The System unit settings
- The Time zone setting
- The Video settings
- The Experimental menu
- Description of the administrator settings
- Cameras
- Appendices
- General room guidelines
- Guidelines for the executive meeting room
- Guidelines for the high end meeting room
- The Video Input Matrix
- Software upgrade
- Upload certificates
- XML files
- Log files
- NTP Time Zone expressions
- Supported RFCs in SIP
- TANDBERG Remote Control TRC5
- TANDBERG Remote Control TRC5 key map
- The PrecisionHD camera
- CE Declaration for Codec C90
- China RoHS table
- TANDBERG Codec C90 dimensions
- PrecisionHD 1080p camera dimensions
- PrecisionHD camera dimensions
- Technical specifications
D14129.02—NOVEMBER 2008
47
Codec C90
Administrator Guide
Contents Introduction Getting started About the menus About the settings Settings Library Cameras Appendices Contact us
Appendices
The software upgrade procedure
Contact your TANDBERG representative to obtain the software upgrade file.
Software upgrade
The Upgrade tab lets you select the software
upgrade file for TANDBERG Codec C90 and install
the new software.
Please follow the procedure described on this
page.
Open a web browser and enter the 1.
IP address to connect to the Codec
C90 by HTTP
Select the 2. Upgrade tab
Click 3. Browse... and locate the
upgrade file (.PKG)
Click the 4. Install software button to
start the installation.
Leave the system for a few minutes 5.
to allow the installation process to
complete. The upgrade process
takes about 4–5 minutes.