Codec C90 User Manual

D14128.02—NOVEMBER 2008
75
Codec C90
System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us
xCommand
xCommand HttpFeedback Deregister
Command used to deregister XML eedback over HTTP(S).
Required parameters with (r):
FeedbackSlot: <1..3>
Example:
xCommand HttpFeedback Deregister FeedbackSlot:1
OK
*r FeedbackDeregisterResult (status=OK):
FeedbackSlot: 1
*r/e n d
xCommand Key Click
Command used to emulate pressing a key on the remote control for a short while. This command needs no
release command.
Required parameters with (r):
Key(r): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Dow n/F1/F2/F3/F4/F5/Grab/Home/
Layout/Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/
Sq uare/SrcAu x/SrcCa m era/SrcDocCa m/SrcPc/SrcVcr/Sta r/Up/Volu meDow n/
Volu meUp/ZoomIn/ZoomOut>
Duration: <0..65534>
Example:
To be described.
xCommand Key Press
Command used to emulate pressing a key on the remote control without releasing it. The Key Press
command should be followed by a Key Release command to emulate releasing the key.
Required parameters with (r):
Key(r): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Dow n/F1/F2/F3/F4/F5/Grab/Home/
Layout/Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/
Sq uare/SrcAu x/SrcCa m era/SrcDocCa m/SrcPc/SrcVcr/Sta r/Up/Volu meDow n/
Volu meUp/ZoomIn/ZoomOut>
Example:
xCommand Key Click Key:Home
*r KeyClickResult (status=OK):
*r/e n d
OK
The Key commands