Codec C90 User Manual

D14128.02—NOVEMBER 2008
42
Codec C90
System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us
About the API
xCommand ?
– User Commands –
OK
About xCommand
xCommand type commands instructs the system to perform an
action. xCommand type commands are supplied by the user.
To get an overview of the supported xCommand type commands,
type ? or help after the xCommand:
xCommand ?•
xCommand help•
To get an overview of all supported xCommand commands with the
corresponding value space, enter ?? after the xCommand:
xCommand ??•
When you type a command and ? or help a list of the available
parameters will show. Required parameters are identified by an (r)
behind the parameter name.
Example:
xCommand Camera Ramp
- the result may look like this:
*h xCom mand Camera Ramp
CameraId(r): <1..7>
Pan: <Left/Right/Stop>
PanSpeed: <1..15>
Tilt: <Down/Stop/Up>
TiltSpeed: <1..15>
Zoom: <In/Out/Stop>
ZoomSpeed: <1..15>
Focus: <Far/Near/Stop>
xCommand ??
*h xCom mand Audio Microphones Mute
*h xCom mand Audio Microphones Unmute
*h xCom mand Audio LocalInput Update
InputId(r): <0..65534>
MixerMode: <Auto/Fixed>
AGC: <On/Off>
Mute: <On/Off>
Channels: <1..2>
*h xCom mand Audio RemoteInput Update
InputId(r): <0..65534>
AGC(r): <On/Off>
*h xCom mand Audio Sound Play
Sound(r): <Busy/CallWaiting/KeyTone/Ringing/SpecialInfo/TelephoneCall/VideoCall>
Loop: <On/Off>
*h xCom mand Audio Sound Stop
*h xCom mand Boot
.
.
.
OK
A return result parameter
The command type
The path
Required (r) parameter
A list of returned parameters
Audio
Boot
Call
CallLog
Camera
Dial
DTMF
FarEndControl
HTTPFeedback
Key
Presentation
Preset
TStringSend
SStringSend
Standby
Video
CamCtrlPip
SystemUnit
Phonebook
Experimental