DLT4000 Tape Backup System Installation Guide

Tandberg Data Installing and Configuring the Tandberg DLT4000 Drive
BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBB
2-8 Tandberg DLT4000 Installation Guide
2.5.2. Connect the SCSI Signal Cable
7RFRQQHFWWKH6&6,VLJQDOFDEOH
 &RQQHFWRQHHQGRIWKH6&6,FDEOHWRWKHOHIWPRVW
6&6,VLJQDOFRQQHFWRURQWKH7DQGEHUJ'/7
UHDUSDQHO
 6QDSWKHZLUHFDEOHFODPSVLQWRSODFHWRVHFXUHWKH
FDEOH
 &RQQHFWWKHRWKHUHQGRIWKH6&6,VLJQDOFDEOHWR
WKH6&6,FRQQHFWRURQ\RXUV\VWHPRUIRUGDLV\
FKDLQHGFRQILJXUDWLRQVWRDQRWKHU6&6,GHYLFH
6HH \RXU V\VWHP GRFXPHQWDWLRQ IRU V\VWHP 6&6, FRQ
QHFWLRQV
2.5.3. Terminate the SCSI Bus
127(
7KH6&6,EXVPXVWEHWHUPLQDWHGDWERWKHQGVDQGDWOHDVW
RQHGHYLFHPXVWVXSSO\WHUPLQDWRUSRZHU
7DEOHWHOOV\RXZKHQDQGZKHUHWRDGGDWHUPLQD
WRU
If the Tandberg DLT4000 is … Then …
The last or only device on the bus
and you are going to terminate the
cables externally
1. Connect the SCSI terminator to one of
the SCSI signal connectors on the
Tandberg DLT4000 rear panel.
2. Snap the wire cable clamps into place or
tighten screws (whichever is supplied) to
secure the terminator.
Not the last or only device on the
SCSI bus
Be sure to install the terminator at the end
of the bus.
7DEOH$GGLQJD7HUPLQDWRU 