Specifications

85 StorageLoader Installation and User Manual
C.4. FRU Magazine
LTO Magazine FRU StorageLoader 1U
Item Part no Description
Qty
1 S808738 Magazine Left LTO 1
2 S808739 Magazine Right LTO 1
See Chapter 4.7. Cartridge Handling for instructions.
After replacing a magazine, pack the defective magazine in the same box you received the
replacement magazine, and return it to your StorageLoader supplier.
C.5. FRU Drive Tray Assy
This part is drive-dependent. Contact your sales representative to get the correct part number.
Pictures shown may vary depending on product model.
Figure C.8. Replacing the tape-drive.
For newer loaders, you must also remove four screws under the loader.
You now have access to the rear of the tape-drive and can dismount the SCSI cable, the ADI cable
and the power cable.
Figure C.9. Rear of the tape-drive.
Release the tape-drive by pushing the spring (see arrow) against the gripper-plate and pulling the
drive carefully backwards.
Power cable
SCSI cable
For replacing the tape-drive, switch off the loader,
disconnect the power cord and remove these two screws
and the back-panel cover plate.
ADI Cable