Specifications

36 Chapter 4. Operation and Configuration.

address, the network mask, and default gateway from a DHCP server, or they can be set manually.

See Table 4.7 below.

Item name Legal values. Default value

Set IP addr.mode Static mode, DHCP mode DHCP mode

Static IP address * Legal IP address range:

000.000.000.000 to

255.255.255.255

Network mask * Legal IP address range:

000.000.000.000 to

255.255.255.255

Default gateway * Legal IP address range:

000.000.000.000 to

255.255.255.255

Access control This menu gives access to dialogs that enables remote

management and remote FW upgrading of the Loader

(see table below). See Table 4.8.

* Used only while the IP address assignment is in Static mode.

Table 4.7. Remote Management Setup Menu.

Item name Legal values. Default value

Allow Remote Management Allowed, Not allowed Allowed

Allow remote FW upg. Allowed, Not allowed Not allowed

Table 4.8. Remote Management Access Control.

4.5. View Data Menu

To enter this menu, scroll to the View Data item in the main menu and press the “Select“ button. See

Table 4.9. The loader will remain in its ready state when this menu is selected.

The View Data menu contains the values assigned during device setup (see Setup Menu) but also

statistical data related to the drive and the robotics. The view-only fields display data that can be

changed from the Setup menu only. If you select the “Change” button and the robot is idle, a dialog

appears where the value may be changed. This requires entry of password if the Loader Password

system is enabled.

Item Name Description

StorageLoader info This menu item gives access to the StorageLoader view

menu.

Drive info This menu item gives access to the Drive view menu.

Remote man. Info This menu gives access to the Selected IP addresses and

masks. This menu also shows the MAC address of the unit.

Statistics This menu item gives access to the Loaders view menus

internal count and statistics values.

Table 4.9. View Data Menu.

4.5.1. StorageLoader Info

An overview of the possible values for each StorageLoader setting is listed in Table 4.10 below.