Specifications

35 StorageLoader Installation and User Manual
4.4. Setup Menu
To enter this menu, scroll to the “Setup“ item in the Main Menu and press the “Select“ button. The
loader enter the busy state when this menu is selected. See Table 4.4 for Setup Menu Items.
Item name Description
StorageLoader setup This menu item gives access to the StorageLoader setup
menu.
SCSI setup This menu item gives access to the SCSI bus setup menu.
Remote Management
setup
This menu item gives access to the Remote Management
setup menu. It allows the operator to enable, disable and
configure the Loader Web interface.
Table 4.4. Setup Menu Items.
4.4.1. StorageLoader setup
The set of selectable values for each StorageLoader setting are listed in Table 4.5 below.
Item name Legal values. Default value
Cleaning Slot Legal Slot ID 1, 8 or, 0 = not selected. 0 = not selected
Barcode scan * Enabled, Disabled Enabled
Audible Alarm Enabled, Disabled Disabled
* Can be enabled only if a barcode scanner is installed. The barcode of the cartridge in each occupied
magazine slot and in the drive (if any) will then be scanned during the Inventory process.
Table 4.5. StorageLoader Settings.
4.4.2. SCSI/SAS Setup
The SCSI setup menu allows selection of SCSI addresses for the internal drive. Because of the SCSI
protocol, the values selected will only take effect after the next power-up of the Loader and Drive. If
your StorageLoader has a SAS tape drive, the Setup Drive ID screen shows the world-wide node
name of the drive. This is not configurable. See Table 4.6 below.
Item name SCSI SAS
Drive SCSI ID 0 to 15 Default: 0 -
World-Wide name - Not configurable
Loader Personality
StorageLoader (default)
AT1280-1R VS160
AT3200-1R LTO2
StorageLoader (default)
AT1280-1R VS160
AT3200-1R LTO2
Table 4.6. SCSI/SAS Settings.
4.4.3. Remote Management setup
The Remote Management Setup Menu allows enabling, configuration and access control to the
Loader via the Loader’s Remote Management Web interface. The loader may either obtain an IP