Specifications

13 StorageLoader Installation and User Manual
LCD – liquid crystal display
The display is a backlit 122 x 32, dot-matrix graphical display that can show four lines of 20
characters.
In various modes of operation, the display panel screens and control buttons allow you to do the
following:
• Enter settings for StorageLoader configuration
• Issue operational commands
• View StorageLoader status and information
• Test StorageLoader functionality
Control Buttons
The labels for the four control buttons are displayed in the corners of the LCD. All buttons have “soft
labelling” for different modes of operation (i.e., the functions and labels of the buttons change during
different activities). The actual soft label for each button for any activity is always visible on the display.
LED Indicators
The two LED indicators are green and amber. They indicate the StorageLoader activity as follows:
• Green LED on: The StorageLoader is either running or ready for operation.
• Green LED blinking: Short blinks followed by long intervals indicate that the loader is in low
power standby mode.
• Amber LED on: Fault LED, the StorageLoader has encountered an electrical or mechanical
failure.
• Both LED’s off: The StorageLoader is offline. This is the case while the loader is initializing,
after power-on, and when a magazine is removed.
Standby Switch
A switch on the front panel provides a standby mode. If the switch is pushed when the loader is active,
the loader will complete the current operation and go off line and enter standby mode, see more
details in Chapter 4.9. Standby Functionality.
Magazine Front Bezel
The front bezel of the magazines is visible from the front. All magazine handling is described in detail
in Chapter 4.8. Magazine Handling.