User manual

Tandberg Data Maintenance
StorageLoader Installation and User Manual 81
Figure 7.2 Example of detailed information
If the problem
persists please call
technical support.
Back
Figure 7.3 Example of further detailed information
In this example, pressing “Back” twice takes you back to the Error
Code Page (figure 7.1) where you can press “Actions” to go to the
Act ions menu. Figure 7.4 shows an example of pressing “Actions”.
Pressing the buttons next to the up/down arrows on the screen gives
you access to other action options.
? Exit
Reboot
? Select
Figure 7.4 Example of action
In figure 7.4, you have been prompted to reboot the Loader. Pressing
“Select” will result in the warning message shown in figure 7.5. Press
“Ok” to execute the reboot.
You are about to
reboot the loade r
AND the drive !
Cancel Ok
Figure 7.5 Warning message concerning reboot
When an error condition occurs, identify the problem using the
displayed error codes and follow the suggested actions. The error
codes are listed in the next section.