User manual

Tandberg Data Maintenance
StorageLoader Installation and User Manual 59
installed . The transport
lock must be removed
prior to operation.
6.4.1 Transport Lock Installation Procedure
To insert the locking screw do the following:
1. If there is a cartridge in the drive, unload the drive first.
When the loader is powered on and idle, push the M enu button
and go to the Prepare to Ship menu entry (see section 0 ,
2. The Maintenance Menus ).
3. If there are any cartridges in the magazines, the loader will
eject those m agazines and a descriptive message will be
shown. Empty the magazines, and put the magazines back in
place.
4. If the magazines are empty, only the right m agazine will be
ejected and a descriptive message will be shown.
5. Turn the main power off at the back of the loader.
6. Rem ove the magazine and insert the locking screw. The red
plastic tab shall protrude from the front of the loader.
7. Insert the magazine and push it in till it locks in place.
6.5 Field Replaceable Units (FRUs)
Tape drives, m agazines, power supply, fans and dust filters are
Field Replaceable Units (FRUs), see figure below. They can easily
be removed/ replaced for quick field service while the loader is
mounted in a rack.