User manual

Tandberg Data Maintenance
StorageLoader Installation and User Manual 55
Debugging
Memory dump will download a snapshot of the system
memory of the loader to a file that can be sent to Tandberg
Data’s service for diagnostic purposes.
Perform a system reset.
Media log displays a log of all cartridge movements and a
map of the current cartridge locations.
6. Maintenance
6.1 Using the Cleaning Cartridge
The cleaning cartridge is similar in size and shape to the regular
DLT/ LTO data cartridge. If your Storage Loader has a barcode
reader, put a cleaning cartridge barcode label on the cartridge
before using it.
Important: This label has a six-digit ID, where the three first
digits are “CLN”.
A cleaning occurs whenever a cleaning cartridge is loaded into the
drive. Before cleaning, you must install the cartridge into the
magazine correctly. The cleaning cartridge m ay be inserted in any
magazine slot.
NOTE: The only absolute authority on Cleaning Tapes is the
drive. The drive will start a cleaning operation whenever a
tape recognized as a cleaning tape is inserted. The Loader
has no way to recognizing a cleaning tape by itsel f . It may be
misleaded by a wrong label on a data tape, by a data tape
inserted in a designated Cleaning Slot, or by the operator.
6.1.1 Running an Installed Cleaning Cartridge
1. Install a cleaning cartridge in a magazine slot in the
loader. If a Cleaning Slot is defined this slot should be
used.
2. Select Clean Drive from the Maintenance section of the
Utilities menu. This will cause the loader to search for a
cleaning cartridge in the following sequence:
a. a cartridge reported to be a cleaning cartridge by the
drive
b. a cartridge with a bar code label indicating that it is a
cleaning cartridge