User manual

Tandberg Data Maintenance
StorageLoader Installation and User Manual 53
If you click on a slot, additional cartridge inform ation will be shown
in a pop up window. This inform ation includes the cartridge
barcode (if label and barcode reader is installed) and the error
code.
5.2.4 Settings Pages
On the setting pages, you can change the StorageLoader
configuration. These pages can only be accessed by someone who
is logged in as Administrator.
Personalization
On this page you can change the Remote Management passwords.
To secure your system , change both the passwords the first tim e
you use the system. It is possible to clear the remote management
passwords via the front panel, please see section 0 The
Maintenance Menus.
Here you may also turn on em ail event notification. When event
notification is enabled, the StorageLoader will send warnings and
errors by email to the r ecipient’s e - mail address.
Network
On this page it is possible to change the IP configuration. See
details in chapter Remote Management setup. The new
configuration will take effect at next system reset.
Warning : Please verify that the chosen settings are correct and
consistent before resetting the loader. Any mistakes will have to be
corrected via the front panel.
SCSI -ID
On this page it is possible to change the SCSI - ID on your drive and
loader. See details in section 4.4.2 , SCSI Setup .
Cleaning Options
By defining a cleaning slot, the StorageLoader will regard the
cartidge in this slot as the cleaning cartridge unless:
1. another cartridge has previously been reported to be a
cle aning cartridge by the drive, or
2. the loader contains a cartridge with a bar code label
indicating that it is a cleaning cartridge.