User manual

Tandberg Data Maintenance
StorageLoader Installation and User Manual 49
2.1. If you want to use a static IP address, use the f ront
panel to enter a valid static IP configuration, see section
4.4.3 , Remote Management setup .
2.2. If you want to configure the network subsystem
dynamically, from the front panel set Setup Rem ote
manage ment setup IP address mode to DHCP mode.
3. Via the front panel, first set Setup Rem ote management
setup Access control Allow remote management to Not
allowed and select OK. Then set the same value to Allowed and
select OK. This will restart the networking subsystem. Getting a
new IP address m ay take some time if the StorageLoader is in
DHCP mode.
4. Check the I P address via the front panel by accessing either
View Data Rem ote management info Sta I P addr. state or
View Data Rem ote managem ent info Dyn IP addr. state
depending on whether the StorageLoader is in static or dynamic
IP address mode.
5.2 Remote management web pages
Most of the operations you can perform from the front panel can
also be performed remotely using Web Administration. The Remote
Management interface provides access to loader and drive status
and statistical operation information.
The Web pages include
a navigation menu
making it easy to use,
see figure 5.1.
Status
Settings
Personalization
Network
SCSI - ID
Cleaning options
C ommand
Maintenance
Diagnostics
Debugging
Figure 5.1 Navigation Menu
5.2.1 Information Boxes
All the Rem ote Management web pages show StorageLoader and
drive information. This information includes:
StorageLoader information containing model, serial num ber,
firmware version, cumulative power-on time and present
activity of the loader.