User manual

Tandberg Data Operation and Configuration
StorageLoader Installation and User Manual 47
1. Finish possible StorageLoader activity.
2. Controlled aborting of tape drive activity; buffered data is
flushed to tape; cartridge is unloaded from drive but not
ejected.
3. The display is turned off.
4. No StorageLoader activity is allowed until standby button is
pressed again.
5. While in standby m ode, the attached server/ host can see the
two SCSI devices in the StorageLoader, but the SCSI status
will be “not ready.”
6. The green LED on the front will blink with short blinks- long
intervals.
7. To leave the standby m ode, press the standby button for 2
second s. The StorageLoader will then restart and perform a
f ull inventory.