User manual

Tandberg Data Operation and Configuration
46 StorageLoader Installation and User Manual
4.8.5 Manual/Emergency Release of Magazines
In case of failure situations either in the loader itself , a power loss,
or if you want to manually release the magazines for some other
reason, a manual/ emergency release is available. To activate the
em ergency magazine feature, you must use the special magazine
release tool which is part of the accessory kit shipped together
with the StorageLoader. This tool must be entered through the
hole marked in figure 4.21.
Note: The manual eject m ust only be used when power is turned
off.
Figure 4.21 Pointing out hole used to insert release tool
Figure 4.22 shows t he
release tool inserted
into the correct hole
on the right hand side
magazine bezel.
Figure 4.22 Magazine release tool in use
4.9 Standby Functionality
On the front panel a standby button is available.
To activate Standby mode, press the button for a minimum of 2
second, the StorageLoader will then enter a standby mode in a
controlled manner. The following takes place before the
StorageLoader goes into standby mode.
Enter the release
tool in hole four from