User manual

Tandberg Data Operation and Configuration
StorageLoader Installation and User Manual 37
* Used only while the IP address assignment is in Static mode.
4.4.3.1. Remote Management Access Control
Item name Legal values . Default value
Allow Remote
Management
Allowe d, Not allowed Allowed
Allow Remote FW
download
Allowed, Not allowed Not allowed
4.5 View Data Menu
To enter this m enu, scroll to the View Data item in the main m enu
and press the Select button. The loader will remain in its ready
state when this menu is se lected.
The View Data m enu contains the values assigned during device
setup (see Setup Menu) but also statistical data related to the
drive and the robotics. The view-only fields display data that can
be changed from the Setup m enu only. I f you select the Change
button and the robot is idle, a dialog appears where the value m ay
be changed. This requires entry of password if the Loader
Password system is enabled.
Item name Description
StorageLoader
info
This menu item gives access to the
StorageLoader view menu.
SCSI info This menu item gives access to the SCSI bus
view menu. Both the StorageLoader and the
Drive SCSI bus parameters are available here.
Remote
Management
info
This menu gives access to the Selected IP
addresses and m asks. This m enu also show s
the MAC address of the unit.
Statistics This menu item gives access to the Loaders
view menus internal count and statistics
values.
4.5.1 StorageLoader Info
An overview of the possible values for each StorageLoader setting
is listed in the following tabl e.
Item name Legal values . Default value