User manual

Tandberg Data Operation and Configuration
36 StorageLoader Installation and User Manual
4.4.2 SCSI Setup
The SCSI setup menu allows selection of SCSI addresses for both
the Loader and its internal drive. In addition, the SCSI bus Parity
can be enabled or disabled. Because of the SCSI protocol, the
values selected will only take effect after the next Reset of the
Loader and Drive.
Item name Legal value s. Default value
Loader SCSI ID Legal SCSI ID: 00..15 04
Drive SCSI ID Legal SCSI ID: 00..15 05
Loader Parity Enabled, Disabled Disabled
Loader
Personality
VS160 : AT1280 - 1R
VS160
LTO : AT1280 - 1R
VS160
AT3200 - 1R LTO2
StorageLoader
VS160 : AT1280 - 1R
VS160
4.4.3 Remote Management setup
The Remote management setup menu allows enabling,
configuration and access control to the Loader via the Loader’s
Rem ote Management Web interface. The loader may either obtain
an IP address, the network mask, and default gateway from a
DHCP server, or they can be set manually.
Item name Legal values . Default value
IP Address
assignment
Static mode, DHCP
mode
DHCP mode
Static IP address
*
Legal IP address
range:
000.000.000.000 to
255.255.255.255
255.255.255.255
Netwo rk mask * Legal IP address
range:
000.000.000.000 to
255.255.255.255
255.255.255.255
Default Gateway * Legal IP address
range:
000.000.000.000 to
255.255.255.255
255.255.255.255
Remote
Management
access control
This menu gives access to dialogs that
ena bles remote management and remote
FW upgrading of the Loader (see table
below).