User manual

Tandberg Data Operation and Configuration
StorageLoader Installation and User Manual 35
Utilities Selects a set of the loader and drive maintenance
and diagnostic functions. The loader must be idle to
make this entry selectable.
See chapter Utili ties Menu for mor e details.
The Main menu can be selected even if the loader is not in the idle
state. While in the main m enu, the loader will accept and execute
SCSI commands. When any of the m ain menu entries except the
View Data entry is selected, the loader will go to it’s busy state
and SCSI com mands will be terminated with Check Condition and
Not Ready status.
4.4 Setup Menu
To enter this menu, scroll to the Setup item in the Main Menu and
press the Select button. The loader enters the busy state when
this menu is sele cted.
Item name Description
StorageLoader
setup
This menu item gives access to the
StorageLoader setup menu.
SCSI setup This menu item gives access to the SCSI bus
setup menu. Both the StorageLoader and the
Drive SCSI bus setup are available here.
Remo te
Management
setup
This menu item gives access to the Rem ote
Management setup menu. I t allows the
operator to enable, disable and configure the
Loader Web interface.
4.4.1 StorageLoader setup
The num ber of selectable values for each StorageLoader setting
are listed in the following table.
Item name Legal values . Default value
Cleaning Slot Legal Slot ID 1..8 or 0 =
not selected.
0 = not selected
Barcode scan* Enabled, Disabled Enabled
Audible Alarm Enabled, Disabled Disabled
Set Language English English
* Can be enabled only if a barcode scanner is installed. The barcode of the
cartridge in each occupied magazine slot and in the drive (if any) will then
be scanned during the Inventory process.