User manual

Tandberg Data Operation and Configuration
32 StorageLoader Installation and User Manual
Examples: If the value “0” or “1” is selected in the Fixed IP
address dialog above, the user is allowed to select
values between “0” and “9” as the nex t two digits.
(The maximum value allowed in this dialog is “255”
within each group.) If, however, “2” is selected, only
values between “0” and ”5” are available in the second
digit. If a value between “0” and “4” is selected for the
second digit, “0” to “9 ” is available for the third, but if
“5” is selected for the second digit, only “0” to “5” is
available for the third one.
Or
the user selects the value “199” in one group in the
above dialog, then presses the “Next Digit” button until
the “1” in “199” is selected, and increments it to “2,”
so the group shows “299.” Since this is an illegal value,
when the user selects the “Next Digit” or the Ok to
leave the group, the value is changed to “255” and the
focus is repositioned to the “2” in the first position of
the group.
Dialogs, Predefined Options
The second form of dialog allows the operator to select between a
predefined set of options, which can be shown on- screen
sim ultaneously, as when selecting a m agazine slot No, see Figure
4.8.
To select a cartridge and move it from a magazine slot to the drive
or vice versa, a slightly different dialog is used:
Ok Cancel
Load to drive
From Slot:
1
35
Figure 4.8 Slot dialog layout.
Here, the right and left arrows select the digit to load from . Ok
accepts the cartridge selected, and Cancel aborts the operation.
Figure 4.9 shows the third form, where the operator can select
predefined options that can be shown only one at a time.
Ok Cancel
Barcode scan
Enabled
Figure 4.9 Predefined options, showed one at the time.