User manual

Tandberg Data Operation and Configuration
24 StorageLoader Installation and User Manual
2. Connect the other end to a normal 10/ 100 BaseT Ethernet
outlet.
The Ethernet-based Remote m anagement system is described in
chapter 5 , Remote Management .
Step 9. Restarting Your System
It is recommended that all external SCSI devices, including the
StorageL oader are powered on before the computer system is re-
started. Turn on the StorageLoader first and wait while the
StorageLoader runs a power up Self-test (like in step 5 above).
When the display reports that the StorageLoader is in the “Idle“
state and the green LED is on, the StorageLoader is ready. Then
turn on the Server/ PC and the system is ready for further
configuration and operation (described in chapter 4 , Operation and
Configuration ).
Note: The tape drive needs up to 40 seconds from power on until
it’s active on the SCSI bus. I t is recommended to turn on the
power at least 40 seconds before the computer system is started.
Step 10. BCR: Label l ing of cartridges
If your loader is equi pped with a bar code reader and you want to
use this functionality, you need to attach bar code labels to the
cartridges.
Note: You need to use StorageLoader specific bar code labels to
ensure reliable functionality of the bar code reader. The bar code
la bels for LTO and DLT cartridges differ.
Cartridge labels must be oriented on the cartridges as shown in
the figures below for LTO cartridges and DLT cartridges
respectively.
Figure 3.11 Positioning of bar code label for LTO cartridges.