User manual

Tandberg Data Operation and Configuration
StorageLoader Installation and User Manual 23
D) Before the StorageLoader is powered on and the system is
restarted, make sure that the SCSI bus is properly
term inated. If the StorageLoader terminates the SCSI bus, it
is recom mended to connect the term inator from the
accessory kit box on the lower SCSI connector on the back
plane. See figure 3.10.
To connect the SCSI bus cable:
1. On the rear of the StorageLoader, attach the device
connector of the SCSI cable to the upper SCSI connector,
see figure 3.10.
2. Secure the cable with the thumbscrews on the connector.
3. Connect the other end of the SCSI cable to the appropriate
SCSI adapter on your system and fasten it with the
thumbscrews.
4. If the StorageLoader is the last device on the SCSI bus,
install a SCSI bus term inator to the free SCSI connector on
the StorageLoader. Make sure that the terminator is of the
correct type for your SCSI system.
5. It is possible to daisy chain several SCSI devices on the SCSI
bus. If you do, the terminator must be connected to the last
devi ce on the bus. Note that there are limitations to the
SCSI cable length.
Figure 3.10 SCSI cable and SCSI terminator connection
Step 8. Connecting the Ethernet Connector
To connect the StorageLoader to the Ethernet, use the provided
cable from the access ory kit box.
1. Insert one end of the cable into the StorageLoader Ethernet
port. Push until it snaps into place. The open port in figure
3.10 is for Ethernet connection.