User manual

Tandberg Data Operation and Configuration
StorageLoader Installation and User Manual 19
Slide the StorageLoader on the rails from the front of the rack, as
shown in figure 3.5. Then fix the StorageLoader using one M6x12
screw in front of the rack on both left and right side (see figure
3.6) and one M5x8 on the backside of the Rack Mounting Kit on
both left and right side (see figure 3.7).
Figure 3.5 Slide the StorageLoader in
from the front
Figure 3.6 Fasten the front of the
StorageLoader to the rack
Figure 3.7 Fasten the rear of the StorageLoader to the rails.
How to dismo unt the StorageLoader from the rack
Make sure that you have disconnected all the cables before you
start dismounting the StorageLoader from the rack.
Unscrew the M5x8 screws at the back of the rack mounting kit.
(See figure 3.7)
Unscrew the M6x12 screw at the front of the rack. Note that you
only unscrew the lowest screw. (See figures 3.5 and 3.6)
Slide the StorageLoader gently out of the rack. Note that the
StorageLoader’s weight is 14.6kg!
Use one M5x8 screw on both left
and right side (M5 - thread) to
fasten the StorageLoader to the
rails’ backside.