User manual

Tandberg Data Operation and Configuration
18 StorageLoader Installation and User Manual
Figure 3.3 Mounting the Rack mounting kit to a rack
Figure 3.4 shows step 5 in the
description:
Rack mounting kit m ounted in
rack with one screw M6x12 in
upper hole on both left and right
side.
On the rear side two screws
must be used on both left and
right side.
Totally six screws are used to
install the “rack mou nting kit” to
the rack.
Figure 3.4 Rack mounting kit
mounted in rack
Mounting the StorageLoader to the Rack
Make sure that all the screws in the Rack Mounting Kit are
tightened properly before installing the StorageLoader in the rack.
Step 5
(Screw
M6x12)
Step 1
Rear Rack
Mount Rail
Use these holes
if rack depth is
equal or longer
than the
StorageLoader
Step 1
Holes to be
used if rack
depth is short er
than the
StorageLoader
Front Rack Mount Rail
Step 5
(Screw M6x12)
Step 2
Step 3
(Screw M4x12,
nut and washer)