User manual

Tandberg Data Operation and Configuration
StorageLoader Installation and User Manual 15
- 2 Line Power Cords: one for USA/ Japan and one for
Eu ropean power outlets
- 1 VHDCI SCSI Interface Cable
- 1 68 - pin VHDCI LVD/SE SCSI Terminator.
- 1 Ethernet cable
- Tool for Emergency Magazine Release
- 30 StorageLoader specific Bar code labels
There will be variations of this list. Please also refer to your Quick
I nstallation guide shipped with the StorageLoader.
Note: The StorageLoader contains no cartridges before shipment.
Step 2. Installing the StorageLoader in a Rack
The StorageLoader is designed for use in 19” rack system using 1U
of rack space. The length of the power cord and the SCSI cable
may restrict the placement.
Attention: The StorageLoader is designed to operate in a
horizontal position. Do not attem pt to operate the StorageLoader
in any other position than horizontally. Also make sure that:
The airflow around the front and back of the StorageLoader
is not obstructed.
There is a minimum of 60cm free space in front of the unit to
allow the operator to safely remove the magazines.
The display and operator controls are easily accessed.
The StorageLoader is away from the floor , and in a clean
environment with temperature within specification, see
Appendix A.
The Rack Mounting Kit includes the following items:
Rail Left Assembly
Rail Right Assembly
Screw M6x12 (6 pieces)
Screw M5x8 (2 pieces)
Recommende d mounting tools: