User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Operation and Configuration
In various modes of operation, the display panel screens and control buttons allow
you to do the following:
• Enter settings for StorageLoader configuration
• Issue operational commands
• View StorageLoader status and information
• Test StorageLoader functionality
Control Buttons
The labels for the four control buttons are displayed in the corners of the LCD. All
buttons have “soft labelling” for different modes of operation (i.e., the functions and
labels of the buttons change during different activities). The actual soft label for
each button for any activity is always visible on the display.
LED Indicators
The two LED indicators are green and amber. They indicate the StorageLoader
activity as follows:
• Green LED on: The StorageLoader is either running or ready for operation.
• Green LED blinking: Short blinks followed by long intervals indicate that
the loader is in low power standby mode.
• Amber LED on: Fault LED, the StorageLoader has encountered an electrical
or mechanical failure.
• Both LED’s off: The StorageLoader is offline. This is the case while the
loader is initializing, after power-on, and when a magazine is removed.
Standby Switch
A switch on the front panel provides a Loader Standby. If the switch is pushed when
the loader is active, the loader will complete the current operation and go off line
and enter standby mode, see more details in chapter
4.9, Standby Functionality.
Magazine Front Bezel
The front bezel of the magazines is visible from the front. All magazine handling is
described in detail in chapter
4.8, Magazine Handling.
StorageLoader Installation and User Manual 7