User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Spares/Accessories
You now have access to the rear of the tape-drive and can
dismount the SCSI cable, the ADI cable and the power cable.
Figure C.9 Rear of the tape drive
Power cable
A
DI cable
Release the tape-drive by pushing the
spring (see arrow) against the gripper-plate
and pulling the drive carefully backwards.
SCSI cable
Figure C.10 Releasing the tape drive
After removing the defective drive, the drive mounting brackets on both sides of the
drive must be removed from the drive, since these will be used for mounting the
replacement-drive. The drive mounting brackets are fastened with two screws each.
The replacement drive comes with a front bezel which is snapped onto the front of
the drive. Remove the front bezel and keep it for use when returning the defective
drive. When fastening the drive mounting brackets to the replacement drive, have
the drive and the brackets laying on a level surface to ensure the brackets are aligned
with the bottom of the drive. Fasten the brackets with two screws each.
Insert the replacement drive carefully into the loader the same way it was removed,
reconnect the 3 cables and re-mount the back plate.
Snap the front bezel that was removed from the replacement-drive onto the front of
the defective drive. Then pack the defective drive in the same box you received the
replacement-drive and return it to your support center.
74 StorageLoader Installation and User Manual