User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Maintenance
Power connector
Fan power cable
Figure C.7 Fan power
After removing the power-supply, insert the replacement unit carefully the same
way, reconnect the 2 cables, fasten the fixing screw and re-mount the back plate.
Then pack the defective power supply in the same box you received the replacement
power supply and return it to your support center.
C.5. FRU Drive Tray Assy
This part is drive dependent. Contact your sales representative to get the correct
part number.
For replacing the tape-drive, switch off the
loader, disconnect the power cord and remove
these two screws and the back-panel cover
plate.
Figure C.8 Replacing the tape drive
StorageLoader Installation and User Manual 73