User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Spares/Accessories
Appendix C – Field Replacement
Units (FRUs)
C.1. FRU Filter
This FRU consists of the following parts:
S808741 Filter FRU StorageLoader 1U
Item Description Qty
1 Filter 1
2 Quick Installation Guide Filter 1
When needed, the dust filter can be
pulled out and a new one slid into
the front-bezel assembly of the
magazines. We recommend
replacing the dust filters once every
year.
Figure C.1 Replacing dust filter
C.2. FRU Magazine
The FRU Magazine for the LTO version consists of the following parts:
LTO Magazine FRU StorageLoader 1U
Item Part no Description
Qty
1 S808738 Magazine Left LTO 1
2 S808739 Magazine Right LTO 1
See section 4.8, Magazine Handling for instructions.
After replacing a magazine, pack the defective magazine in the same box you
received the replacement magazine, and return it to your StorageLoader supplier.
C.3. FRU Fan
This FRU consists of the following parts:
S808740 Fan FRU StorageLoader 1U
70 StorageLoader Installation and User Manual