User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Maintenance
If the problem
persists please call
technical support.
Back
Figure 7.3 Example of further detailed information
In this example, pressing “Back” twice takes you back to the Error Code Page (figure
7.1) where you can press “Actions” to go to the Actions menu. Figure 7.4 shows an
example of pressing “Actions”. Pressing the buttons next to the up/down arrows on the
screen gives you access to other action options.
▲ Exit
Reboot
▼ Select
Figure 7.4 Example of action
In figure 7.4, you have been prompted to reboot the Loader. Pressing “Select” will
result in the warning message shown in figure 7.5. Press “Ok” to execute the reboot.
You are about to
reboot the loader
AND the drive !
Cancel Ok
Figure 7.5 Warning message concerning reboot
When an error condition occurs, identify the problem using the displayed error codes
and follow the suggested actions. The error codes are listed in the next section.
StorageLoader Installation and User Manual 61