User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Maintenance
• Make sure that the fuse located beside the power
connector on the rear panel is not blown. Replace fuse if
blown (a spare fuse is located behind the fuse door).
• Remove the back panel cover plate and verify that all
cables are connected properly.
• Replace the FRU power supply.
• Contact your service representative.
The display is dead
• Power cycle the loader by turning off and on the main
power switch on the rear of the loader.
• Verify that the fans start at power on and then stops after a
few seconds.
• Check the power cord connection.
• Make sure the main power switch on the rear panel is in
the ON position.
• Make sure there is power to the outlet. Try another working
outlet.
• Replace the power cord.
• Make sure that the fuse located beside the power
connector on the rear panel is not blown. Replace fuse if
blown (a spare fuse is located behind the fuse door).
• Remove the back panel cover plate and verify that all
cables are connected properly.
• Replace the FRU power supply.
• Contact your service representative.
The front panel does not display
information but the back light on
the front panel is on
• Power cycle the loader by turning off and on the main
power switch on the rear of the loader.
• Verify that the fans start at power on and then stops after a
few seconds.
• Contact your service representative.
Cartridge movement
Loader does not take inventory • Make sure the transport screw is removed.
• Make sure both magazines are in their locked position.
• Look up the error code; follow the instructions in the
“suggested action” column.
• Contact your service representative.
StorageLoader Installation and User Manual 55