User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Maintenance
Figure 5.4 Remote Management Command Page
5.2.6 Maintenance Pages
On these pages it is possible to select predefined tests and actions in order to check
the reliability of the StorageLoader.
Diagnostics
• Clean the drive by importing a cleaning cartridge.
• If you choose Identify loader, the front panel display light will toggle on and
off for 15 seconds. This makes it easy to verify that you are connected to the
correct loader if several loaders are stacked.
• Test robotics by moving cartridges.
• Test robotics without moving cartridges.
Debugging
• Memory dump will download a snapshot of the system memory of the loader
to a file that can be sent to Tandberg Data’s service for diagnostic purposes.
• Perform a system reset.
• Media log displays a log of all cartridge movements and a map of the current
46 StorageLoader Installation and User Manual