User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Maintenance
If you click on a slot, additional cartridge information will be shown in a pop up
window. This information includes the cartridge barcode (if label and barcode reader
is installed) and the error code.
5.2.4 Settings Pages
On the setting pages, you can change the StorageLoader configuration. These pages
can only be accessed by someone who is logged in as Administrator.
Personalization
On this page you can change the Remote Management passwords. To secure your
system, change both the passwords the first time you use the system. It is possible to
clear the remote management passwords via the front panel, please see section 0 The
Maintenance Menus.
Here you may also turn on email event notification. When event notification is
enabled, the StorageLoader will send warnings and errors by email to the recipient’s
e-mail address.
Network
On this page it is possible to change the IP configuration. See details in chapter
Remote Management setup. The new configuration will take effect at next system
reset.
Warning: Please verify that the chosen settings are correct and consistent before
resetting the loader. Any mistakes will have to be corrected via the front panel.
SCSI-ID
On this page it is possible to change the SCSI-ID on your drive. See details in
section 4.4.2, SCSI Setup.
Cleaning Options
By defining a cleaning slot, the StorageLoader will regard the cartridge in this slot as
the cleaning cartridge unless:
1. another cartridge has previously been reported to be a cleaning
cartridge by the drive, or
2. the loader contains a cartridge with a bar code label indicating that it
is a cleaning cartridge.
5.2.5 Command Page
On this page it is possible to move cartridges between magazine slots and drive. All
cartridges in the StorageLoader will be found in a pull-down list sorted by location.
The other pull-down list shows the empty locations where it is possible to move the
cartridge to.
StorageLoader Installation and User Manual 45