User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Maintenance
5.2.3 Status Page
The StorageLoader Status page looks like the figure below.
Figure 5.3 Remote Management Status Page
The figure provides an updated status of drives, robotics and cartridges using color-
coding and symbols.
The Drive and Robot status will be shown as a green (OK), yellow (Warning) or red
(Error) dot. If you click on the text, additional information will be shown in a pop up
window.
The cartridge locations are shown with rectangles in the slots or the drive. The status
codes are:
• Black
Empty slot, no cartridge present
• Grey
Cartridge present
• Blue
Cleaning cartridge in the slot
• Yellow
Warning
• Red
Error
44 StorageLoader Installation and User Manual