User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Maintenance
up.
2. The default language is English.
• Log in for further use of Remote Management. The system has two levels of
login. By default the passwords are blank, i.e. type in the user ID and leave
the password field blank. To secure your system, change both passwords
under Settings > Personalization, the first time Remote Management is used.
1. The user ID Administrator has full access to the Remote Management
pages.
2. The user ID Operator has limited access to the Remote Management, and
cannot access the Settings and Maintenance pages.
Figure 5.2 Remote Management Start Page
Note: StorageLoader network traffic is not encrypted, so anyone with physical
access to the network path will be able to access the information with a packet
sniffer. Passwords, however, are encrypted. It is not possible to reach the plaintext
password, but it is possible to sniff “the challenge key” and use it to gain access.
The system is therefore not safer than the network it is using.
If you need high security, make sure packets to and from the StorageLoader do not
leave the secure network, and employ separate encryption when traffic traverses
insecure networks.
StorageLoader Installation and User Manual 43