User manual

Tandberg Data Maintenance
mode.
3. Via the front panel, first set Setup → Remote management → Access control →
Allow remote management to Not allowed and select OK. Then set the same
value to Allowed and select OK. This will restart the networking subsystem.
Getting a new IP address may take some time if the StorageLoader is in DHCP
mode.
4. Check the IP address via the front panel by accessing either View Data →
Remote man. info → Static IP address or View Data → Remote man. info →
Dynamic IP address depending on whether the StorageLoader is in static or
dynamic IP address mode.
5.2 Remote management web pages
Most of the operations you can perform from the front panel can also be performed
remotely using Web Administration. The Remote Management interface provides
access to loader and drive status and statistical operation information.
The Web pages include a
navigation menu making it
easy to use, see figure 5.1.
Status
Settings
Personalization
Network
SCSI-ID
Cleaning options
Command
Maintenance
Diagnostics
Debugging
Figure 5.1 Navigation Menu
5.2.1 Information Boxes
All the Remote Management web pages show StorageLoader and drive information.
This information includes:
• StorageLoader information containing model, serial number, firmware
version, cumulative power-on time and present activity of the loader.
• Drive information containing technology, serial number, firmware version
and activity.
5.2.2 StorageLoader Start Page
After successfully connecting to the StorageLoader from your browser, you will see
the StorageLoader Start page, figure 5.2. This contains:
•
Select language for user-interface.
1. The language used last time will come up as the default language at start-
42 StorageLoader Installation and User Manual