User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Operation and Configuration
Figure 4.22 shows the
release tool inserted into
the correct hole on the right
hand side magazine bezel.
Figure 4.22 Magazine release tool in use
4.9 Standby Functionality
On the front panel a standby button is available.
To activate Standby mode, press the button for a minimum of 2 seconds, the
StorageLoader will then enter a standby mode in a controlled manner. The following
takes place before the StorageLoader goes into standby mode.
1. Finish possible StorageLoader activity.
2. Controlled aborting of tape drive activity; buffered data is flushed to tape;
cartridge is unloaded from drive but not ejected.
3. The display is turned off.
4. No StorageLoader activity is allowed until standby button is pressed again.
5. While in standby mode, the attached server/host can see the SCSI device in
the StorageLoader, but the SCSI status will be “not ready.”
6. The green LED on the front will blink with short blinks- long intervals.
7. To leave the standby mode, press the standby button for 2 seconds. The
StorageLoader will then restart and perform a full inventory.
40 StorageLoader Installation and User Manual