User manual

Tandberg Data Operation and Configuration
4.8.4 Inserting a Magazine into the Unit
The right and left magazines are mirrored and can only be inserted into the correct
left or right magazine bay. See figure 4.20.
1. Enter the back of the magazine into the correct magazine bay. Make sure it is
in level with the loader.
2. Slide the magazine carefully in until the eject spring engages.
3. Push the magazine further in against the spring until the magazine is latched.
Figure 4.20 Push magazine until it clicks into place
4.8.5 Manual/Emergency Release of Magazines
In case of failure situations either in the loader itself, a power loss, or if you want to
manually release the magazines for some other reason, a manual/emergency release
is available. To activate the emergency magazine feature, you must use the special
magazine release tool which is part of the accessory kit shipped together with the
StorageLoader. This tool must be entered through the hole marked in figure 4.21.
Note: The manual eject must only be used when power is turned off.
Enter the release tool in
hole four from the center
Figure 4.21 Pointing out hole used to insert release tool
StorageLoader Installation and User Manual 39