User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Operation and Configuration
4.5.1 StorageLoader Info
An overview of the possible values for each StorageLoader setting is listed in the
following table.
Item name Legal values. Default value
Loader Serial No. Loader Serial number. ---
Loader Slots State View status for each loader
slot
Not applicable
Loader personality AT1280-1R VS160
AT3200-1R LTO2
StorageLoader
StorageLoader
Loader product ID Current HW/FW Product Id AT3200-1R LTO2
Loader Vendor ID Current Inquiry Vendor Id “TANDBERG”
Loader FW part No See the product label See the product label
Loader FW
revision
StorageLoader FW id and
revision
xx.yy
Cleaning Slot Defined cleaning slot, No set Not set
Barcode Reader * Enabled, Disabled Enabled if installed, else
Disabled
Audible Alarm Enabled, Disabled Disabled
* Can only be enabled if a barcode scanner is installed.
4.5.2 Drive Info
The different drive types used in the StorageLoader may not provide all the
information listed below. If an unavailable entry is selected, the string “Data
Unavailable is displayed.
Item name Legal values Default value
Drive Product ID Drive Inquiry Product Id Drive dependent
Drive Vendor ID Drive Inquiry Vendor Id Drive dependent
Drive FW Revision Drive Firmware Revision Drive dependent
Drive Serial No. Drive Serial Number Drive dependent
Drive SCSI Id SCSI Id 0 to SCSI Id 15 SCSI ID = 5
32 StorageLoader Installation and User Manual