User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Operation and Configuration
loader may either obtain an IP address, the network mask, and default gateway from
a DHCP server, or they can be set manually.
Item name Legal values. Default value
Set IP addr.mode Static mode, DHCP mode DHCP mode
Static IP address * Legal IP address range:
000.000.000.000 to
255.255.255.255
255.255.255.255
Network mask * Legal IP address range:
000.000.000.000 to
255.255.255.255
255.255.255.255
Default gateway * Legal IP address range:
000.000.000.000 to
255.255.255.255
255.255.255.255
Access control This menu gives access to dialogs that enables remote
management and remote FW upgrading of the Loader
(see table below).
* Used only while the IP address assignment is in Static mode.
4.4.3.1. Remote Management Access Control
Item name Legal values. Default value
Allow Remote
Management
Allowed, Not allowed Allowed
Allow remote FW upg. Allowed, Not allowed Not allowed
4.5 View Data Menu
To enter this menu, scroll to the View Data item in the main menu and press the
Select button. The loader will remain in its ready state when this menu is selected.
The View Data menu contains the values assigned during device setup (see Setup
Menu) but also statistical data related to the drive and the robotics. The view-only
fields display data that can be changed from the Setup menu only. If you select the
Change button and the robot is idle, a dialog appears where the value may be
changed. This requires entry of password if the Loader Password system is enabled.
Item name Description
StorageLoader info This menu item gives access to the StorageLoader view
menu.
Drive info This menu item gives access to the Drive view menu.
Remote man. info This menu gives access to the Selected IP addresses and
masks. This menu also shows the MAC address of the unit.
Statistics This menu item gives access to the Loaders view menus
internal count and statistics values.
StorageLoader Installation and User Manual 31