User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Operation and Configuration
Dialogs and the Messages.
4.2.1 Menus
The major contributor is the MENU. It is used to select operations to perform by
enabling the operator to navigate a menu tree using the control buttons.
Due to the size of the display, only one menu item is shown at a time. See figure 4.4
for a standard menu layout and figure 4.5 for a complete menu tree.
▲ EXIT
Menu Entry.
▼ SELECT
Figure 4.4 Standard Menu Layout
The two filled arrows on the left are used to show the next (down arrow) and
previous (up arrow) entries on the current menu level.
The Exit button on the right is used to ascend to the menu level above, while the
Select button is used to descend to the submenu designated by the Menu Text, or to
activate the function selected if the Menu Entry describes a function.
24 StorageLoader Installation and User Manual