User manual

Tandberg Data Operation and Configuration
The Drive Status line (line 3) can show the following status:
1 Drive Empty There is no cartridge in the drive
2 Drive Loaded A Cartridge is Loaded.
3 Drive Idle A Cartridge is loaded and the drive is ready
to use it
4
Drive Rewinding The Drive is rewinding the tape
5
Drive Seeking The drive is searching for specific data on
the tape
6
Drive Reading The drive is reading data for transfer to a
host via the SCSI interface
7
Drive Writing The drive is writing data received from a
host to the tape
8
Drive Erasing The drive is erasing data from parts of or
the whole of the tape.
9
Drive Cleaning A Cleaning Tape has been inserted in the
Drive and the drive is using it to clean the
relevant mechanical parts
10
Drive Loading A tape has been inserted in the drive. The
drive is in the process of mechanically
loading it
11
Drive Unloading The drive is in the process of mechanically
unloading the tape
12
Drive Update Ready The Drive has completed an internal
update.
13
Drive Updating The drive is in the process of an internal
FW update
14 Drive Calibrating A data tape ha been inserted and loaded
into the drive. The drive is in the process of
measuring its physical properties.
Table 4-2 Drive Operation Statuses
4.2 Front Panel Display Modes
The front panel displays three types of screens for different purposes: the Menus, the
StorageLoader Installation and User Manual 23