User manual

Tandberg Data Operation and Configuration
Figure 3.5 Slide the StorageLoader in
from the front
Figure 3.6 Fasten the front of the
StorageLoader to the rack
Use one M5x8 screw on both left
and right side (M5-thread) to
fasten the StorageLoader to the
rails’ backside.
Figure 3.7 Fasten the rear of the StorageLoader to the rails.
How to dismount the StorageLoader from the rack
Make sure that you have disconnected all the cables before you start dismounting
the StorageLoader from the rack.
Unscrew the M5x8 screws at the back of the rack mounting kit. (See figure 3.7)
Unscrew the M6x12 screw at the front of the rack. Note that you only unscrew the
lowest screw. (See figures 3.5 and 3.6)
Slide the StorageLoader gently out of the rack. Note that the StorageLoader’s weight
is 14.6kg!
Step 3. Connecting Power Cable
AC connection
Before connecting the StorageLoader to your host computer system you should run
the self-diagnostic of the unit. This preparation requires power to the StorageLoader.
Go through the following steps to perform this test:
1. Use the power cables from the accessories included in the shipment. Make
sure you select the power cord suited for your power system.
2. Plug the power cable into the rear of the StorageLoader (see figure 3.8). Plug
16 StorageLoader Installation and User Manual