User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Operation and Configuration
3. Installation
This chapter provides step-by-step instructions on how to properly prepare and
install the Tandberg Data StorageLoader.
READ ME FIRST
CAUTION! !
YOU MUST REMOVE THE
ROBOT TRANSPORT LOCK
WHEN POWERING UP THE UNIT FOR THE FIRST TIME
OR IT WILL NOT OPERATE.
SEE THE PROCEDURE ON THE FOLLOWING PAGES.
3.1 Performing the Installation
To install the StorageLoader, complete the following steps.
Step 1. Unpacking the StorageLoader
Carefully unpack the unit from the shipping container. Save the container and
packing materials in case you need to transport the StorageLoader in the future. The
packaging is specifically designed for the loader to ensure it is not damaged during
transportation.
Review the contents of the shipping container to be sure that all parts were included
in the shipment. A standard package for the StorageLoader consists of the following
items:
• A factory-assembled StorageLoader unit containing two cartridge
magazines.
• A Standard Accessory Kit containing:
- 1 Printed copy of the Quick Installation Guide
- 1 Warranty/Registration Card
- Rack Mount Hardware Kit
- 2 Line Power Cords: one for USA/Japan and one for European
power outlets
- 1 SCSI Interface Cable
StorageLoader Installation and User Manual 11